Guide d’installation P. 13
Example: If the multi-level features were set to option 3, the setup would be as follows:
Level 1 Customized feature
Level 2 Multi car operation
Level 3 Basic features
The “Basic features” are now programmed as level 3 and therefore:
To access the aux. 2 feature, the user needs to press on the FUNCTION button three (3) times
followed by the LOCK button.
To access cold weather mode, the user needs to press on the FUNCTION button three (3) times
followed by the START/STOP button.
Diagnostics – Parking Light Flash Table
Flashes Description
1
• Doors locked, starter kill armed.
• End of run time.
• TRUNK button pressed
• Start signal received by the module.
• Cold weather mode cancelled.
• Cannot start after maximum number of attempts is reached.
2
• Doors unlocked, starter kill disarmed.
• Run time cancelled.
• Remote start attempt cancelled by remote.
• Exiting remote valet
• Exiting ignition valet
3
• Entering cold weather mode.
• Entering extended run time.
• Entering remote valet
• Entering ignition valet
4
• +12 V where detected on the brake line and cranking was cancelled.
• Entering tach-programming mode
5
• New transmitter programmed.
• Tach programmed.
6
• A remote start was attempted while a tach or a vacuum signal was detected before
cranking.
8 • Unit reset: occurs when the unit is reset to the factory defaults.
10 • The hood switch line went to ground during cranking or run time.
1 – pause – 2 • There was an attempt to start the vehicle while the module was in valet mode.
ON solid • Cold weather mode: the brake pedal is being held down.
2 – pause – 2 • There was an attempt to start the vehicle while the module was in home valet mode.
ON 2 sec.
• The hood is up and the hood switch line went to ground. This is step one of the
programming centre procedure.
ON 3 sec. • First press of the START button under safe start.
ON 4 sec. • Locking or unlocking a door (with door pulses configured to 4 sec.)
ON 25 sec.
• The hood pin-switch has been pressed twice: the unit went into step 1 of the
programming centre procedure, and no transmitter activity was detected for 20
seconds.
• Or the unit went into step 1 of the transmitter programming procedure and no activity
was detected for a few seconds. The unit has exited the transmitter programming
procedure.
Irregular
• If the unit gives irregular signals (1 to 10 flashes followed by a pause, followed by
further flashes), the system is playing back start failure codes. This occurs when the
hood pin-switch is pressed three times
Constant
flashes
up to 30 sec.
• Panic mode is triggered.
(15 pages)
(33 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals